Safety and compliance information for Ring Keypad (1st Generation)
Use responsibly. Read all instructions and safety information before use.
Safety Information
WARNING: Failure to read and follow these safety instructions before operation could result in fire, electric shock, or other injury or damage.
This device is for indoor use only. Do not expose your device or adaptor to liquids. If your device or adaptor gets wet, carefully unplug all cables without getting your hands wet and wait for the device and adaptor to dry completely before plugging them in again. Do not attempt to dry your device or adaptor with an external heat source, such as a microwave oven or a hair dryer. If the device or adaptor appear damaged, discontinue use immediately. Use only accessories supplied with the device to power your device. To avoid risk of electric shock, do not touch your device or any wires connected to your device during a lightning storm.
WATCH FOR SMALL PARTS: Your device and accessories may present a choking hazard to small children. Keep them out of reach of small children.
CAUTION: To reduce the risk of electrical shock, DO NOT open the unit. There are no user serviceable parts inside the unit. Refer to customer service for any repairs.
Class II apparatus
For indoor use
Battery Safety
HANDLE WITH CARE: Your device contains a rechargeable lithium-ion battery and should be replaced only by a qualified service provider. Do not disassemble, open, crush, bend, deform, puncture, shred or attempt to access the battery in your device. Do not modify or remanufacture the battery, attempt to insert foreign objects into the battery, or immerse or expose it to water or other liquids, expose to fire, explosion or other hazard. Only use the battery for the system for which it is specified. Use of an unqualified battery or charger may present a risk of fire, explosion, leakage or other hazard. Do not short-circuit a battery or allow metallic conductive objects to come into contact with battery terminals. Avoid dropping the device or battery. If the device or battery is dropped, especially on a hard surface, and the user suspects damage, do not attempt repair. Contact customer service for assistance.
Product Specifications
Model Number: 4AK1E9-0EU0
Electrical Rating: 5.0V DC 1.0A
Maximum Power Consumption in Networked Standby*: 0.5W
Adaptor Model: DSA-5CD-05 050100
Adaptor made by: Dee Van Enterprise Co., Ltd
Temperature Rating: 0°C - 40°C
* Ring Keypad automatically enters “Networked Standby” immediately after active communication is completed.
Wall Mounting
1. Place the mounting bracket on the wall, then use the wall anchors and screws from your kit to fasten the bracket to the wall (If using anchors, you should pre-drill holes).
2. Slide the Keypad onto the bracket. Screws: 3x 3x21mm. Anchors: 3x 5mm.
Declaration of Conformity
Hereby, Ring LLC, declares that the radio equipment Ring Keypad (4AK1E9-0EU0) is in compliance with Directive 2014/53/EU and UK Radio Equipment Regulation, RER 2017 (S.I. 2017/1206), including currently valid amendment(s). The full texts of the declarations of conformity and other applicable statements of compliance for this product are available at the following internet address: www.ring.com/DoC
Wireless Features: Z-Wave
Maximum Radio Frequency Power: 868.4 - 869.85 MHz 4.2 dBm EIRP
Radio Frequency Compliance
In order to protect human health, this device meets the thresholds for exposure of the general public to electromagnetic fields according to Council Recommendation 1999/519/EC. This device should be installed and operated with at least 20 cm between the radiator and your body. For Z-Wave technical information, visit ring.com/z-wave.
Recycling Your Device Properly
In some areas, the disposal of certain electronic devices is regulated. Make sure you dispose of, or recycle, your device in accordance with your local laws and regulations. For information about recycling your device, go to www.amazon.com/devicesupport.