Understanding doorbell light patterns
Learn about light patterns for video doorbells. All video doorbell models show the same light patterns unless stated otherwise.
Blue circle light filling clockwise over time: Charging
This indicates that a video doorbell with a built-in battery is charging. The location of the light indicates charge percentage. Video doorbells with a Quick Release Battery Pack do not display this light pattern.
- Upper right quadrant of the blue circle light is flashing: The video doorbell is charging from 0-25%.
- Right half of the blue circle light is flashing: The video doorbell is charging from 25-50%.
- Most of the blue circle light is flashing: The video doorbell is charging from 50-75%.
- Blue circle light is flashing: The video doorbell is fully charged.
White light spinning in a circle: Setup mode
The video doorbell is in setup mode. This light pattern times out after 10 minutes.
Blue circle light moving upward: Wifi connecting
The video doorbell is connecting to your wifi network during setup.
Four corner blue LEDs flashing: Setup successful
The video doorbell has successfully completed setup. This pattern will not display for Ring Video Doorbell Elite.
White circle light flashing repeatedly: Updating firmware
The video doorbell is updating its firmware.
White light flashing right side: Setup failed
The video doorbell could not connect to the home wifi network. Common causes include distance or special characters in the wifi name.
White light flashing on top: Setup failed
The video doorbell setup failed due to an issue with the wifi password.
White light flashing left side: Setup failed
The video doorbell was able to connect to wifi but could not reach Ring’s servers or the internet.
Blue light spinning in a circle clockwise: Doorbell pressed
The video doorbell button was pressed.
Solid blue circle light: Active call
The video doorbell is in an active call and the speaker enabled.
Blue circle light flashing slowly: Factory reset
The video doorbell is performing a factory reset. This pattern applies to all battery-powered video doorbells except Door View Cam.
Blue circle light flashing followed by white light circling clockwise: Factory reset
The video doorbell is performing a factory reset. This pattern applies to the Door View Cam and all wired doorbells.
Solid white circle light: Idle mode
The video doorbell is idle. This pattern applies to hardwired video doorbells and battery-powered video doorbells that are hardwired.
Lights are off: Idle mode
The video doorbell is idle. This pattern only applies for battery-powered video doorbells that are not hardwired.
Blue circle light flashing slowly: Boot (power up)
The video doorbell is powering up. This pattern only applies to Video Doorbell Wired and Battery Doorbell Plus.
White light filling circle slowly then flashing: Boot (power up)
The video doorbell is powering up. This pattern only applies to the Wired Doorbell Plus and Wired Doorbell Pro.
Red light flashing bottom: Insufficient power
The video doorbell does not have enough power. This pattern only applies to wired video doorbells that are not battery-powered.
