Installing Your Ring Car Cam Holder
Support your Ring Car Cam with the Car Cam Holder.
Follow these instructions to install:
1. Prepare to place Car Cam Holder.
Before you peel the adhesive tape, find and test a good spot on your lower windshield place the holder. Be sure not to cover any of your car's dashboard sensors. Don't wedge the holder against the dashboard with excessive force.
2. Clean the windshield area.
Using the included cleaning pads, thoroughly wipe down the windshield surface where you plan to place the holder and remove any dust, grease, and other residue. Let dry a few minutes.
3. Remove the tape and gently place.
Without the Car Cam device inserted, peel back the adhesive tape on the holder and place it on the chosen lower portion of the windshield – ensuring you stay clear of any of your vehicle's sensors. It should sit flush with the dashboard.
4. Gently hold in place for 30 seconds.
Don't use excessive force. Just keep Car Cam Holder in place for half a minute.
5. Check the strap and slide in your Car Cam device.
Ensure the strap is unlatched, and slide the device into the holder slot.
6. Secure Car Cam with the strap.
Once Car Cam has been fully secured into the Holder, pull the rubber strap to the latched position, securing it across Car Cam’s body.
Removing your Car Cam Holder
- Park your vehicle and shut off your engine.
- Unlatch the rubber strap, and slide Car Cam out of the holder.
- Use dental floss to cut through the adhesive pad using sawing motion, working your way from the top to the bottom of the adhesive pad.
- Once through the adhesive pad, the holder should dismount naturally. You may need to pull and twist the holder lightly to release.
- Peel any remaining residue off of the windshield with your hands or use an adhesive remover (e.g. Goo Gone).